This is the Class board for the Curvemeister 101 class.
2 posts • Page 1 of 1
Done according to instructions with a b channel mask.I used background channels 3&4 for adjustments to top or bottom of image.I used image>adjust rather than CM simply because it was a click away and I wasn't sure what would happen with the masks if I went to CM.GregM
- templifigures-jpg (999 Bytes) Viewed 1514 times
Just remember the masking is an after effect not the main purpose of CM. It was found that many effective masks were made by using a channel and jacking up the contrast. CM supports mask creation but it is not the be all and end all of masking...The mask is a simple tool when you think it through. It simply blocks the adjustment from showing through the current layer. You can apply a mask to the underlying layers. They only effect the current layer adjustment.
Who is online
Users browsing this forum: No registered users and 0 guests