Benny c1s3 example 4

mikemeister_admin
Posts: 4925
Joined: Fri Sep 20, 2013 8:29 pm

Postby mikemeister_admin » Sat Jun 02, 2007 11:35 am

LAB first. Used a set neutral in the lighter shadow under the chairs. This got rid of most of the blue colour cast.
Moved saturation up and steepened the curve at the dark end.
The opened in RGB. Didn't think there was any blue still remaining under the chairs until I moved the blue dark end about half a square then noticed the slight change to a more natural sandy colour. Great suggestions in the session notes.
Amazing how such simple changes can make such a huge change to an image.
Benny

mikemeister_admin
Posts: 4925
Joined: Fri Sep 20, 2013 8:29 pm

Postby mikemeister_admin » Sat Jun 02, 2007 11:36 am

Am I correct in thinking there may be a slight yellow colour cast now?

-default
Posts: 1916
Joined: Thu Mar 26, 2015 1:53 am

Postby -default » Sun Jun 03, 2007 8:43 pm

The problem isn't too much yellow, but too much green in the foliage - on my monitor it looks oversaturated.  In general, foliage should be more yellow than green on the hue clock.  The sand and sky are great, so I would concentrate on the green half of the a curve in Lab mode to level out the green a bit, without affecting the sky.


Return to “May 2007 Curvemeister 101”

Who is online

Users browsing this forum: No registered users and 1 guest