If you can see this board, you are enrolled in the July 2007 class
2 posts • Page 1 of 1
Started in LAB setting neutral and adjusting highlight and shadow threshold. Set neutal point carefully to neutralize rock face in the sun. Used hue clock to assess the shadows -- they were quite blue. Exited CM2 and reentered to make RGB adjustments. Set sample points in the shadows. Adjusted R G B in the dark area >70% to neutralize shadows (pinned whole curve to avoid changing balance in higlight area). Had to compromize a bit -- I couldn't make all three channels the same for all points...tried to minimize the differences and make them as small as possible. After finishing curves exited CM2 again and sharpened.
Who is online
Users browsing this forum: No registered users and 1 guest