Posted: Thu Sep 13, 2007 9:23 am
Hello again
Adjusting this image, without ND points is challanging in RGB and HSB.
The white and black point settings are difficult to set with any accuracy.
However the differances that I observed were:
RGB and Lab were very close and HSB was oversaturated.
I did not feel the need to increase the saturation in Lab mode. As doing so tended to lose some of the detail.
Once again I chose Lab, not because the RGB was inferior, but because there is always the possibility of easily adjusting the saturation further if required.
Regards
Adjusting this image, without ND points is challanging in RGB and HSB.
The white and black point settings are difficult to set with any accuracy.
However the differances that I observed were:
RGB and Lab were very close and HSB was oversaturated.
I did not feel the need to increase the saturation in Lab mode. As doing so tended to lose some of the detail.
Once again I chose Lab, not because the RGB was inferior, but because there is always the possibility of easily adjusting the saturation further if required.
Regards