Page 1 of 1
Posted: Tue Aug 26, 2008 1:37 am
by mikemeister_admin
First image is as per instructions.Second I masked off the top and jacked up the color in the painting.As I remember,if you raise the color in the top half too much you blow out the carved jade the warriors are on.
Posted: Tue Aug 26, 2008 2:26 am
by ggroess
Since you have the top mask can you invert it on another layer and fix both sides of the image??
Just a thought...
Greg
Posted: Tue Aug 26, 2008 5:01 pm
by mikemeister_admin
Had never tried this before.Tookfirst submission here and used second pass to set highlight and shadowand lift the lightness a bit
Posted: Tue Aug 26, 2008 6:56 pm
by ggroess
Not to bad....for a first pass...
Good job...
Greg
Posted: Sat Aug 30, 2008 8:22 pm
by mikemeister_admin
Here is a quick effort. I am not at all satiosfied with it, and will try again.
-- Russ
Posted: Sat Aug 30, 2008 10:14 pm
by ggroess
It's not too bad but you are right there is more in there to bring out...
Greg
Posted: Sun Aug 31, 2008 7:25 pm
by mikemeister_admin
OK, I made another run at this image. I set myself a goal of bringing up the darker figures in addition to darkening the bright portion. To do this, I first used the S channel as a mask and then lowered the bright end of the L channel. Next I wanted to mess with the lower portion of the L curve, but with the mask in effect I could not do anything useful in the dark areas. So I exited CM, then flattened the image, and then reopened CM and reset all the curves so that I could regain control of the entire tonal range. Is there another, easier or better way to do this? In other words, can you get rid of the mask in some other way once it had one its job?
-- Russ