Page 1 of 1
Posted: Mon Feb 02, 2009 11:59 pm
by mikemeister_admin
Want to see how this transmits.First pass,by the numbers,2.slight lizzard tail in HSB for hair and right side of face,3.in RGB removed some blue-purple.
Posted: Tue Feb 03, 2009 1:16 am
by ggroess
Why was there some purple left over to remove in the last step??
The BTN correction should have gotten that out...Was it localized to some part of the image?? or a general cast??
Greg
Posted: Tue Feb 03, 2009 10:18 pm
by mikemeister_admin
Today I went back and redid image,onlyone step.The top one is the image I get when I apply and save as and is slightly different than the image as displayed.I prefer the blue Tee shirt of the bottom picture.
Posted: Tue Feb 03, 2009 10:47 pm
by mikemeister_admin
I downloaded the bluer Tee shirt image and there was a shift back to the magenta side of B on the hue clock?
Posted: Wed Feb 04, 2009 10:26 pm
by ggroess
are you saving a different profile than the default sRGB?
That could be messing with you. The web display is always suspect as well. I'll look at them later tonight and see if I can see anything on my setup.
Greg
Posted: Wed Feb 04, 2009 10:27 pm
by mikemeister_admin
To get some fill light to the face.First step was a background copy set to screen,opacity60% then this BTN.When I used a lizzard tail to lighten the side of the face somethingelse seemed to change in the image.
Posted: Wed Feb 04, 2009 10:38 pm
by mikemeister_admin
I have sRGB set under prefs.
Posted: Thu Feb 05, 2009 1:18 am
by ggroess
so let me get this straight...
Step 1 background copy, screen, set to 60% opacity, then CM on the same layer? Is the background getting 40% of the way through your correction?? then copy and screen??
that might be where the color is coming from??
Greg
Posted: Thu Feb 05, 2009 4:30 am
by mikemeister_admin
This was a variation on my usual workflow.I can see that if you don't lock the colors the opacity could perhaps do some filtering on its own.GregM