Eran's week 3 work:

This is the Class board for the Curvemeister 101 class.
Post Reply
eransh10
Posts: 45
Joined: Tue Oct 13, 2009 4:17 pm

Postby eransh10 » Sat Oct 24, 2009 4:54 pm

Sorry for the late post- I had a busy week.
Anyway - these images weren't so hard to work at.
I hope I did a good job. Also I didn't look at the answers when I worked on these .....  8)
Attachments
drummers-jpg-2
drummers-jpg-2 (999 Bytes) Viewed 6317 times
blue-cast-jpg
blue-cast-jpg (999 Bytes) Viewed 6317 times
building-jpg-2
building-jpg-2 (999 Bytes) Viewed 6317 times
ggroess
Posts: 5342
Joined: Wed May 24, 2006 2:15 am
Contact:
Contact ggroess

Postby ggroess » Sat Oct 24, 2009 11:14 pm

I think you are pretty close...A bit warm i.e. red...It is a tough choice as to har far to go with reds when skin tones are present.  I would say the give away was the overall tone of the image...It just felt warm...

See screen shot and ACV file if you like...
Greg
Attachments
screenshot002-jpg-84
screenshot002-jpg-84 (118.35 KiB) Viewed 6317 times
drummers-jpg-lab_gg-acv
(70 Bytes) Downloaded 332 times
ggroess
Posts: 5342
Joined: Wed May 24, 2006 2:15 am
Contact:
Contact ggroess

Postby ggroess » Sat Oct 24, 2009 11:21 pm

Again you are really pretty close.  I'm wondering if your monitor is a bit differeent from mine the correction for this is very simular to the previous...the image has too much red in it...When I Pinned the yellow side of the B curve and added a sky pin....Shot3....

Greg
Attachments
screenshot003-jpg-52
screenshot003-jpg-52 (80.99 KiB) Viewed 6317 times
ggroess
Posts: 5342
Joined: Wed May 24, 2006 2:15 am
Contact:
Contact ggroess

Postby ggroess » Sat Oct 24, 2009 11:23 pm

Nicely done...The skin tones are well handled and you kept the blue out of the shadows...

Greg
Attachments
screenshot004-jpg-32
screenshot004-jpg-32 (132.97 KiB) Viewed 6317 times
eransh10
Posts: 45
Joined: Tue Oct 13, 2009 4:17 pm

Postby eransh10 » Sat Oct 24, 2009 11:53 pm

Hi Greg,
My monitor is calibrated with the color Munkie.
I use it to also to profile my printer.

Eran.
ggroess
Posts: 5342
Joined: Wed May 24, 2006 2:15 am
Contact:
Contact ggroess

Postby ggroess » Sun Oct 25, 2009 12:29 am

hmmm..must be the difference via the web....

It does happen and I usually allow enough variation to not make it an issue...let's see if the red shift persists..

Greg
Post Reply

Return to “Curvemeister 101 September 2009”

Who is online

Users browsing this forum: No registered users and 1 guest