Page 1 of 1
Posted: Fri Jan 01, 2010 11:22 pm
by mikemeister_admin
I used RGB to get the blue in the sky and the green in the copper,then an s curve in Lab for some detail to the left panel of the spire.GregM
Posted: Fri Jan 01, 2010 11:32 pm
by ggroess
Greg,
Kinda heavy in the shadows...were you going for a different feel?
Greg
Posted: Sat Jan 02, 2010 1:08 am
by mikemeister_admin
I found the shadow detail and surface grit on the copper sheets were closely linked.I might try another pass to separate them.GregM
Above I posted the picture minus the contrast curve but a curve in the k channel of CMY and a saturation boost.GregM