It has been very quiet out here and I want to make sure you are getting to the pages....
Greg
Everyone getting to the assignments page??
Oh Yes, I forgot why I have been so late in posting.
I have a problem with CM 3 for Elements version 3.2.0.
I installed it and when I began to work on the duck picture, I got this odd curve in Lab mode in the lightness panel. It does not make a curve but stays straight. What is also strange is the version number displayed on the top bar showing 3.1.0.0 and not ver 3.2. See the screen-shot. I deffinatly installed version 3.2.0. twice to check.
I re-installed ver 3.0.1.2 and it works as it should. See screen-shot. The Lightness curve makes a curve.
Most peculiar
Maybe I should send the info to Mike, but I am too lazy to start a second post.
Regards
kessi
I have a problem with CM 3 for Elements version 3.2.0.
I installed it and when I began to work on the duck picture, I got this odd curve in Lab mode in the lightness panel. It does not make a curve but stays straight. What is also strange is the version number displayed on the top bar showing 3.1.0.0 and not ver 3.2. See the screen-shot. I deffinatly installed version 3.2.0. twice to check.
I re-installed ver 3.0.1.2 and it works as it should. See screen-shot. The Lightness curve makes a curve.
Most peculiar
Maybe I should send the info to Mike, but I am too lazy to start a second post.
Regards
kessi
- Attachments
-
- cm-ver-3-1-0-0-jpg (102.32 KiB) Viewed 6670 times
-
- cm-ver-3-0-12-jpg (115.52 KiB) Viewed 6670 times
-
- Posts: 4927
- Joined: Fri Sep 20, 2013 8:29 pm
Return to “Curvemeister 101 March 2010”
Who is online
Users browsing this forum: No registered users and 26 guests