Hello.
I had some difficulty with this image. I selected the gold to make sure that it would not be dimmed. I used Lab mode with the B channel mask. What do yo think of it?
Thank you
David
Week 6 - Example 7 - Temple Fugures
Hello
I decided to try this image again because I really was not satisfied with my first try. I sleeted the gold along with the top half of the image. I then inverted the selection. I used the B channel as a mask with some adjustments. I adjusted the L channel. Finally, I moved the saturation slider to the left rather than the right (applied some desaturation). I believe this try is better than the previous one. What do you think of it?
Thank you
David
I decided to try this image again because I really was not satisfied with my first try. I sleeted the gold along with the top half of the image. I then inverted the selection. I used the B channel as a mask with some adjustments. I adjusted the L channel. Finally, I moved the saturation slider to the left rather than the right (applied some desaturation). I believe this try is better than the previous one. What do you think of it?
Thank you
David
- Attachments
-
- 20110130_example7-templefugures-lab2_screenshot1-jpg (173.38 KiB) Viewed 12834 times
David,
While B is a good choice for this image you can get even further by looking at the saturation mask. Apply a light to medium blur using the mask commands in CM. Start by balancing the exposure over the two halves of the image. Then adjust the saturation using the LAB slider.
Give it another try...
Greg
While B is a good choice for this image you can get even further by looking at the saturation mask. Apply a light to medium blur using the mask commands in CM. Start by balancing the exposure over the two halves of the image. Then adjust the saturation using the LAB slider.
Give it another try...
Greg
-
- Posts: 4927
- Joined: Fri Sep 20, 2013 8:29 pm
Hello
I decided to re-do this image. This time I used the S channel as a mask with blur set to wide. I believe this is the best one so far. What do you think of this image?
Thank you
David
I decided to re-do this image. This time I used the S channel as a mask with blur set to wide. I believe this is the best one so far. What do you think of this image?
Thank you
David
- Attachments
-
- 20110130_example7-templefugures-schannelmasklab3_screenshot1a-jpg (43.99 KiB) Viewed 12834 times
-
- 20110130_example7-templefugures-lab3_screenshot1b-jpg (169.18 KiB) Viewed 12834 times
Return to “Curvemeister 101 - December 2010”
Who is online
Users browsing this forum: No registered users and 3 guests