K channel mask with GCR set to 100. Followed procedure set out in video. Used lightness channel to control mask blur. Added 2 extra pin in L curve to bring out detail in clouds
dan
sun moon lake using only CM
-
- Posts: 130
- Joined: Thu Oct 04, 2012 3:00 pm
-
- Posts: 130
- Joined: Thu Oct 04, 2012 3:00 pm
Hey Dan,
Two minor issues with this one.
Shot 1 shows the tree line. The noise might be coming from the mask so take a good look at it to see if you can eliminate some of the edge noise. try reducing the blur if you can. Also the image has a slight yellow cast to it...see screen shots below.
Greg
Two minor issues with this one.
Shot 1 shows the tree line. The noise might be coming from the mask so take a good look at it to see if you can eliminate some of the edge noise. try reducing the blur if you can. Also the image has a slight yellow cast to it...see screen shots below.
Greg
- Attachments
-
- greg01-jpg-4 (52.84 KiB) Viewed 4704 times
-
- greg02-jpg-3 (259.79 KiB) Viewed 4704 times
Return to “Curvemeister 101 - March 2013”
Who is online
Users browsing this forum: No registered users and 31 guests