Hi eyerybody,
this is a topic for all technical stuff, in which we hopefully helps each other and make it easier for Greg to find these questions.
My first problem is, that sometimes the curve don't wanna move, when I set a contrast pin and want to rotate the curve.
Did you guys have this too? Or is there a trick?
Greetings, Tanja
Thread for all technical problems
-
- Posts: 130
- Joined: Thu Oct 04, 2012 3:00 pm
Anybody:
Tanja, thanks for setting up the technical area. How can I look at the photo in CM without having the curve grid over it block my view. I can control the size of the picture, make it large or small with the wheel on my mouse and I can make the curve grid large or small by double clicking it. But I like a big picture and a large curve grid simultaneously. Also, I may start out with a large master rgb grid, but if I use multiple layers, invariably I end up with the master, the red, green and blue all in one box and they all are too small. I want to control the size of the cm grid i use.
dan
Tanja, thanks for setting up the technical area. How can I look at the photo in CM without having the curve grid over it block my view. I can control the size of the picture, make it large or small with the wheel on my mouse and I can make the curve grid large or small by double clicking it. But I like a big picture and a large curve grid simultaneously. Also, I may start out with a large master rgb grid, but if I use multiple layers, invariably I end up with the master, the red, green and blue all in one box and they all are too small. I want to control the size of the cm grid i use.
dan
-
- Posts: 130
- Joined: Thu Oct 04, 2012 3:00 pm
-
- Posts: 294
- Joined: Mon Feb 04, 2013 2:15 pm
-
- Posts: 294
- Joined: Mon Feb 04, 2013 2:15 pm
Tanja,
Sometimes the "focus" of the mouse is not on the curve window even when you have just clicked it...I'm not sure but sometimes you need a second click to get the focus on the curves window and enable the contrast pin movement.
Hope that helps
Greg
In germany we called that "Vorführeffekt".
I try no 10 times having a "not moving" curve to try that extra click, but now the curve moves all times. Typical ;D
But I have that in mind for the next time.
Thanks Greg!
Ok...easy fix...
Shot1: click on the window frame header and then drag the frame to the right edge of the CM interface. You should see a blue box like shot 2. Release the mouse and the frame should dock to the CM interface window.
Greg
Shot1: click on the window frame header and then drag the frame to the right edge of the CM interface. You should see a blue box like shot 2. Release the mouse and the frame should dock to the CM interface window.
Greg
- Attachments
-
- shot1-jpg-4 (66.51 KiB) Viewed 11569 times
-
- shot2-jpg-3 (72.74 KiB) Viewed 11569 times
-
- Posts: 130
- Joined: Thu Oct 04, 2012 3:00 pm
Dose the Curves frame dock to the side of the interface??
The image will center in the image window no matter what.
If you dock the panel to the right side the Image window will change shape and the image will center in it unless we have something going on I am not aware of...
The Curves panel should not float free unless you want it to.
Greg
The image will center in the image window no matter what.
If you dock the panel to the right side the Image window will change shape and the image will center in it unless we have something going on I am not aware of...
The Curves panel should not float free unless you want it to.
Greg
Return to “Curvemeister 101 - March 2013”
Who is online
Users browsing this forum: No registered users and 25 guests