Page 1 of 1
Posted: Mon Oct 20, 2008 3:41 pm
by j2e4a8n
Well, I tried a lot on this one.
Check for the floare when corrected for exposure
Posted: Mon Oct 20, 2008 5:56 pm
by imported_ganna
CM and I touched this :)
Posted: Mon Oct 20, 2008 6:19 pm
by ggroess
Very nice...
Jean,
The flare might have to be tackled on the individual channels...
Greg
Posted: Mon Oct 20, 2008 8:06 pm
by j2e4a8n
CM and I touched this :)
See the kind of oblique window above the guy legs
Can we get rid of that?
Posted: Sat Oct 25, 2008 10:50 pm
by mikemeister_admin
Nice work Ganna.I selected the group and the shadow and pulled down the brightness,result looks kinda photoshopped.Maybe some sort of selection and gradient fill,problem is flare continues along shadowline and back to camera.
Posted: Sun Oct 26, 2008 5:38 am
by imported_ganna
CM and I touched this :)
See the kind of oblique window above the guy legs
Can we get rid of that?
It will take lots of time and patience and I still don't know what result to expect. Can try with the clone stamp tool to get rid of the hard transition between light and dark but I do not know of an easy way to do it.
Posted: Sun Oct 26, 2008 4:19 pm
by ggroess
You could try:
Split channels from the channels pallet. Edit each separate image in B&W to remove the flare in gray scale.
Then copy each channel back into the original replacing the old flared channel with the new repaired channel.
The commands are just copy and paste using the channels pallet and if you take a few minutes you can get a fairly good repair.
More time and effort would only help.. I have 5 minutes into this...
Posted: Sun Oct 26, 2008 5:05 pm
by imported_ganna
Thanx Greg, this is a new method to me. Will give it a try.