Page 1 of 1
Posted: Wed Feb 25, 2015 3:41 am
by imported_julie
Hi
I seem to have some sort of bug
Started the last few days
I can duplicate it mostly using CMYK with a mask and cyan adjustment
Julie
Posted: Wed Feb 25, 2015 12:50 pm
by -default
OK, thanks Julie. I'll try to recreate the problem. Can you give me the size of the image in pixels, and also your version of Curvemeister and Photoshop and whether you are 32 or 64 bits? Thanks.
Mike
Posted: Wed Feb 25, 2015 1:28 pm
by ggroess
Julie,
What mask were you using??
Greg
Posted: Wed Feb 25, 2015 9:09 pm
by imported_julie
Hi
I will give all the details when I get home from work.
Greg I think it was a b mask.
I was trying to isolate the sky
I could make it happen again but not consistently
Julie
Posted: Thu Feb 26, 2015 9:02 am
by imported_julie
Mike
Image size 4288 x 2848 pixels
Adobe Photoshop Version: 13.0.1 (13.0.1.3 20131024.r.34 2013/10/24:21:00:00) x64
curvemeister3 v 3.8.2
hope this helps
Julie
Posted: Thu Feb 26, 2015 9:04 am
by imported_julie
Hi just did it again using a reversed b mask
Julie
Posted: Sun Apr 26, 2015 3:10 am
by julie
Hi
I'm noticing it again
only seems to occur when using CMYK and a mask
This was a hue mask but as you can see from the above it has happened on another mask
I have included a screen shot showing what happens
The square is always in the same place
Julie
Posted: Sun Apr 26, 2015 4:20 pm
by julie
I just made the sky purple to demonstrate the bug.
It's not what I would have been aiming for
I regularly use CMYK and a mask to remove some cyan from skies
Also it's not visible in CM only when saved to PS
Julie
Posted: Mon Apr 27, 2015 3:34 am
by mikemeister_admin
Hi Julie.
Does this problem happen every time?
Thanks.
Posted: Mon Apr 27, 2015 4:31 am
by julie
Yes but not with every mask. I was able to go back into cm and repeat this to send to you. The original correction was a much more subtle blue
Julie