Page 1 of 1
Posted: Fri Nov 16, 2007 1:38 am
by mikemeister_admin
Well, I also like the size of the newer mask carte, but now it doesn't work the same way it did in 3.0.2. If I pick a b mask (fer instance) and make my curves adjustment, I can no longer choose other masks from the ribbon and see the changes in the preview, like I could this morning; if I change to a skin mask I see no change in the preview window, though the name changes in the curve window and in the dropdown.
If I reset and choose the skin mask, however, it does change and show the same curve and mask I was just using on the b channel. Also, I'm sorry to say none of the masks will invert or blur right now.
I'm not sure what Greg did this time.
Posted: Fri Nov 16, 2007 2:11 am
by -default
I can reproduce this one every time - it's necessary to go through "no mask" in order to change to a different mask channel.
I'm sure it's not really Greg's fault :-)
Posted: Fri Nov 16, 2007 2:25 am
by mikemeister_admin
Is this intentional, then? Because it wasn't this way in 3.0.2, was it? It appears more and more as if it is Greg's...little lapse.
Posted: Fri Nov 16, 2007 4:44 am
by -default
No, sorry - it's definitely a bug. The mask should change the way it used to, with just one click. Invert and blur should work the way they did too.
Posted: Fri Nov 16, 2007 5:00 am
by mikemeister_admin
Well good. I was preparing a case. :) If you could have that fixed before Saturday...that'd be great...
(Did you see "Office Space" ?)
Posted: Fri Nov 16, 2007 11:35 am
by -default
Masks were very broken. It's fixed now with v3.0.4.
Posted: Fri Nov 16, 2007 7:50 pm
by ggroess
huh...
Sorry i was snoozing a bit...What did I miss??
Greg
Posted: Fri Nov 16, 2007 8:11 pm
by mikemeister_admin
The masks were messed up--yesterday. I just assumed you were behind that. Sorry if I jumped to conclusions, Greg.
Posted: Fri Nov 16, 2007 8:56 pm
by ggroess
I might have messed them up with my bad install on the 3.0.2 build..but they seem to be much better today...
Greg